1)
To strip the bolt, start by holding bolt
handle in right hand. Pull back slightly on
cocking piece and then slowly rotate it
counter clockwise.
2)
This is the ending position of the cocking
piece.
3)
Using a small flat tip, depress the
retaining pin at the back of the bolt.
4)
Unscrew and remove the cocking piece nut.
5)
Remove the cocking piece from the bolt, it
slides off.
6)
Note the flat part on the firing pin.
Remember this alignment to the safety lever
for assembly purposes.
7)
Depress the safety and rotate counter
clockwise. Note the location of the pin in
the notch of the bolt body.
8)
Note where the pin is after releasing
tension on the safety lever.
9)
This is where the pin has to be in order to
remove the safety and firing pin from the
bolt body.
10)
Press the safety in slightly and rotate it
until the pin is in this side notch and the
firing pin will be released. Be careful, the
items are under spring tension.
11)
Bolt
parts.
Reassembly
Instructions
12) Place firing spring on firing pin and
insert into bolt body.
13) Attach safety, align pin with bolt body
and press down and rotate clockwise until
pin is locked into notch.
14) Note pin is aligned in notch of bolt
body.
15) Push safety level down and rotate
further clockwise until pin is locked into
the lower portion of the bolt body (as seen
in photo).
16) Rotate firing pin so that flat aligns as
you noted when you dissembled the bolt.
17) Slide cocking piece onto firing pin
(flat portion will have to align correctly).
18) Screw on the cocking piece nut.
19) Finally depress the retaining pin and
rotate until it is tight and the pin is
aligned with the notch in the cocking piece
nut.
20) Grip bolt by hand, pull back on cocking
piece and rotate clockwise.
