|
Disassembly
Instructions |
|
|
| 1) figure 1 shows
the Madsen rifle.
NOTE: Make sure rifle is unloaded and pointed in a safe
direction before proceeding.
|
|
|
| 2) Open bolt
and pull to rear of receiver. |
|
|
| 3) While keeping
the trigger depressed, remove the bolt and set aside. |
|
|
| 4) Depress retaining
spring on bayonet lug band as shown in figure
4. |
|
|
| 5) Slide the
bayonet lug band forward. |
|
|
| 6) The lower
band is also held in place by a retaining spring. |
|
|
| 7) Depress the
retaining spring and slide the lower barrel band forward. |
|
|
| 8) Remove the
lower barrel band by sliding it forward. You will have to
slide the handguard as well since it has a lip located at
its front. |
|
|
| 9) Once the
handguard is far enough forward you can slide the lower barrel
band off and forward. |
|
|
| 10) Remove the
handguard and set aside. |
|
|
| 11) Unscrew the
trigger guard front screw. |
|
|
| 12) Remove the
trigger guard front screw. |
|
|
| 13) Unscrew the
trigger guard rear screw. |
|
|
| 14) Remove the
trigger cover rear screw. |
|
|
| 15) Press down
on the magazine cover release and slide the magazine cover
forward. |
|
|
| 16) Remove the
magazine cover. |
|
|
| 17) Remove the
trigger guard. |
|
|
| 18) Remove the
barrel and receiver assembly from the stock. |
|
|
| 19) Figure 19 shows
the disassembled rifle. |
|
Reassembly Instructions |
|
|
| 20) Place barrel
and receiver assembly back into the rifle stock as shown
in figure 20. |
|
|
| 21) Place the
handguard back onto rifle. |
|
|
| 22) Replace the
lower barrel band and push to rear. |
|
|
| 23) Depress the
retaining spring and slide the lower barrel band till
it is locked in place. |
|
|
| 24) Depress
retaining spring for the bayonet lug band as shown in
figure 24. |
|
|
| 25) Slide the
bayonet lug band until it locks in place. |
|
|
| 26) Replace
trigger guard. |
|
|
| 27) Install
rear trigger guard screw. |
|
|
| 28) Install front
trigger guard screw. |
|
|
| 29) Tighten
rear trigger guard screw. |
|
|
| 30) Tighten
front trigger guard screw. |
|
|
| 31) Place magazine
follow and spring back into rifle as show in
figure 31. |
|
|
| 32) Press down
on the magazine cover release and slide magazine cover
into place until it locks. |
|
|
| 33) Return bolt
to receiver. |
|
|
| 34) Press down
on magazine follower and close bolt. |
|
|
| 35) Figure 35
shows the reassembled rifle. |
File Downloads
